Safety switches for Brisbane northside and Moreton Bay homes
A safety switch (RCD) watches the power flowing through a circuit. If some of it leaks to earth, for example through a person touching a faulty appliance, it cuts the power in a fraction of a second. It’s the difference between a nasty fright and a fatal shock.
Plenty of older homes on Brisbane’s northside still have no safety switches at all, or just one covering the power points while the lights, air con and oven run unprotected. We install safety switches and upgrade switchboards so every circuit is covered.
Call 1800 230 400 or request a quote online.
Does your home have safety switches?
Open your switchboard and look for switches with a “T” or “Test” button. Those are safety switches (or RCBOs, which combine a safety switch and a circuit breaker in one). Then check:
- No test buttons at all? Your home has no safety switch protection.
- Ceramic fuses? The board is old, and almost certainly unprotected.
- One or two safety switches covering everything? One fault can black out half the house, and some circuits may not be covered.
Not sure what you’re looking at? Send us a photo of your switchboard with the cover open and we’ll tell you.
What Queensland requires
- New homes: safety switches have been compulsory in new Queensland homes since 1992, and on both power point and lighting circuits since 2000.
- Buying a home: if the power point circuits aren’t protected by a safety switch, the buyer must have one installed within three months of the property transfer. Sellers must declare whether there’s one on the sale contract.
- Rentals: all power point circuits in rental properties must be protected by a safety switch.
These are the minimums. Our advice is simple: protect every circuit. That’s what current wiring rules (AS/NZS 3000) require when a switchboard is replaced or new circuits go in.
Our options
Add safety switches to your existing board
If your board is in decent condition and has room, we can often fit safety switches without replacing it. Quickest and simplest.
Upgrade to RCBOs on every circuit
With an RCBO on each circuit, a fault on one circuit only trips that circuit. The fridge stays on when the outdoor power point gets wet, and faults are far easier to find.
Full switchboard upgrade
Ceramic fuses, a cramped or damaged board, or no room for new circuits means it’s time for a new one. See switchboard and meter box upgrades.
Test them every three months
Queensland’s Electrical Safety Office recommends pressing the test button on each safety switch every three months. The switch should trip straight away. If it doesn’t, or it won’t reset, call us. Expect the power to go off on that circuit when you test, so reset your clocks afterwards.
Safety switch FAQs
My safety switch keeps tripping. Should I replace it?
Usually the switch is fine. It’s doing its job. The cause is normally a faulty appliance, water in an outdoor power point or light, or damaged wiring. Unplug everything on that circuit and reset it. If it still trips, call us to find the fault.
Is a safety switch the same as a circuit breaker?
No. A circuit breaker protects the wiring from overload and short circuits. A safety switch protects people from electric shock. An RCBO does both.
Do I need a safety switch if I’m selling my house?
You must declare whether the power point circuits have one. If they don’t, the buyer has to install one within three months of settlement, so fitting one before you sell removes a question mark for buyers.
Can I install a safety switch myself?
No. In Queensland, switchboard work must be done by a licensed electrician.
Why Armitage Electrical
- Licensed electrical contractor, QLD licence 88297
- We’ll tell you straight whether you need a few safety switches or a new board
- Servicing Brisbane’s northside and Moreton Bay from Brendale and Aspley
Enquire online
Tell us about your switchboard. A photo with the cover open helps us quote faster.
